Most disputes in the dried seaweed trade come down to two numbers: how much the shipment weighed and how much of that weight was water. Seller and buyer each measure honestly, get different results and then argue over who is right. The way to avoid this is not better arguing but a contract that decides, before anything is shipped, how weight and moisture will be measured, by whom, and what happens when results differ.
Why the numbers drift apart
Dried seaweed is not a stable product. It exchanges moisture with the air, so a lot weighed in a humid warehouse and weighed again after weeks at sea will not give the same figure, even if nothing has gone wrong. On top of that natural drift come differences in method:
- Different test methods: an oven test at one temperature and duration, a different oven method, or a handheld meter can give different moisture results on the same seaweed.
- Different samples: a handful from the top of a few sacks is not the same as a sample drawn systematically from across the lot.
- Different scales: an uncalibrated scale at either end can create a gap that looks like a loss.
- Different timing: results taken at loading and on arrival reflect different conditions and different amounts of time in storage.
Our posts on how moisture is measured and sampling a seaweed lot explain the technical side.
Clauses that prevent disputes
A contract that settles the following points in writing removes most of the room for disagreement:
- The reference test method. Name the moisture method, including temperature and duration for an oven test, and state that it prevails over quick meter readings.
- The point of measurement. Decide whether weight and moisture are final at loading or on arrival. Loading-based terms put more weight on pre-shipment inspection; arrival-based terms put more on the buyer’s intake procedure.
- Sampling rules. Specify how many sacks are sampled, how the sample is mixed and divided, and how it is sealed and labelled.
- Counter-samples. Require sealed duplicate samples to be kept by each party, and by the surveyor if one is used, for a set period.
- Tolerance. Agree a margin within which differences between two results are accepted without adjustment.
- Price adjustment. State how the price changes for each unit of moisture above the limit, and at what level the buyer may reject the lot.
- Umpire testing. Name who resolves a disagreement, usually an independent laboratory testing a sealed counter-sample, and who pays for it.
Joint sampling and independent surveyors
Where the relationship is new or the volume is significant, an independent inspection company can witness weighing, draw and seal samples, and issue a report at loading. That report then becomes the agreed reference for the shipment. It costs money, but far less than a disputed container. In an established relationship, joint sampling by representatives of both sides can serve the same purpose at lower cost.
Either way, record the conditions: date, weather, warehouse, sack count and gross and net weights. Photographs of sealed samples and of the loaded container help as well. Our post on loading a container covers what to document on the day.
When a difference appears anyway
Even with good clauses, results will sometimes fall outside tolerance. The practical order is to check the paperwork first, looking for transcription errors and differences in method, then compare sample handling, and only then send the counter-sample to the agreed umpire laboratory. Both sides should accept the umpire result as final, as the contract says. Relationships usually survive a dispute that is handled by the rules they agreed in advance; they rarely survive one that is not.
Frequently asked questions
Is a moisture meter good enough for contracts?
Meters are useful for quick checks at collection and in the warehouse, but they need calibration against an oven method for each type of seaweed. For contract purposes, an agreed oven method is normally the reference.
Who should pay for an independent surveyor?
It is negotiable. Often the party who asks for it pays, or the cost is shared. What matters most is that the contract names the surveyor, or how one will be chosen, before shipment.
Should weight loss in transit be expected?
Some change in weight can happen as dried seaweed adjusts to new conditions. A tolerance clause exists for that reason. Large or repeated differences point to a problem with drying, sampling or weighing that should be investigated.
Working with Kospermindo
Kospermindo has long-term partnerships with processing factories and exporters and a warehouse in the Makassar Industrial Estate. To discuss supply terms, contact us.

